The mib module, containing XG radio options.
This value indicates XG unit role in radio link.
Syntax: INTEGER { master(0), slave(1) }
This value indicates cell id.
Syntax: Integer32 (0..167)
This value indicates QoS strategy.
Syntax: INTEGER { normal(0), conservative(1), aggressive(2), off(3) }
Desirable ratio of downlink traffic related to all traffic in percents.
Syntax: Integer32 (1..99)
Radio frame length in milliseconds.
Syntax: INTEGER { len-1-ms(1), len-2-ms(2), len-4-ms(4), len-5-ms(5), len-8-ms(8), len-10-ms(10) }
This value indicates maximum allowed length of radio link in meters for auto-ranging algorithm.
Syntax: Integer32 (0..59600)
Selected radio channel width in MHz.
Syntax: INTEGER { band-10-mhz(10), band-20-mhz(20), band-40-mhz(40) }
A table of radio configuration options by carrier index.
Syntax: SEQUENCE OF XgCarrierCfgEntry
Each entry contains configuration options for separate radio carrier.
Syntax: XgCarrierCfgEntry
Radio carrier index, ranging from 1 to maximum carrier number used.
Syntax: Integer32 (1..2)
Maximum allowed TX power in thousandths of dB, stepping by 250.
Syntax: Integer32 (0..27000)
Radio carrier frequency in MHz for downlink traffic.
Syntax: Integer32
Radio carrier frequency in MHz for uplink traffic.
Syntax: Integer32
If auto, then TX MCS is set to be upper value that is chosen by adaptive algorithm. If manual, then TX MCS is set to be equal to that value.
Syntax: INTEGER { auto(0), manual(1) }
Instructs MCS adaptive algorithm to prefer maximum radio bandwidth over radio transport block error rate or vice versa.
Syntax: INTEGER { normal(0), conservative(1), agressive(2) }
XG Radio Interface index. The interface identified by a particular value of this index is the same interface as identified by the same value of RFC 1573's ifIndex.
Syntax: Integer32 (0..2147483647)
XG radio link status.
Syntax: INTEGER { stopped(0), starting(1), down(2), up(3), error(4), phy(5) }
Estimated length of radio link in meters.
Syntax: Integer32
Estimated portion of allowed downlink traffic related to all traffic in percents.
Syntax: Integer32 (1..99)
Amount of transmitted radio frames.
Syntax: Counter32
Amount of Ethernet packets transmitted via radio interface.
Syntax: Counter32
Amount of received radio frames.
Syntax: Counter32
Amount of Ethernet packets received from radio interface.
Syntax: Counter32
Amount of received valid air blocks.
Syntax: Counter32
Amount of received invalid air blocks.
Syntax: Counter32
Estimated capacity for downlink traffic in Kbps.
Syntax: Integer32
Estimated capacity for uplink traffic in Kbps.
Syntax: Integer32
A table of radio data by carrier index.
Syntax: SEQUENCE OF XgRfCarrierStatEntry
Each entry contains carrier-specific data by carrier index.
Syntax: XgRfCarrierStatEntry
Radio carrier index, ranging from 1 to maximum carrier number used.
Syntax: Integer32 (1..2)
Good Rx Frames counter.
Syntax: Counter32
Bad Rx Frames counter.
Syntax: Counter32
Tx frequency, MHz
Syntax: Integer32
Rx frequency, MHz
Syntax: Integer32
DFS status: dfs-no-init(0), dfs-disabled(1), dfs-enabled(2), dfs-fg-radar-search(3), dfs-fg-rssi-scan(4), dfs-radar-found(5), dfs-bg-rssi-v(6), dfs-bg-rssi-h(7), dfs-bg-rdrdt-main(8), dfs-bg-rdrdt-announce(9), dfs-bg-FF-ul(10), dfs-bg-FF-dl(11).
Syntax: INTEGER { dfs-no-init(0), dfs-disabled(1), dfs-enabled(2), dfs-fg-radar-search(3), dfs-fg-rssi-scan(4), dfs-radar-found(5), dfs-bg-rssi-v(6), dfs-bg-rssi-h(7), dfs-bg-rdrdt-main(8), dfs-bg-rdrdt-announce(9), dfs-bg-FF-ul(10), dfs-bg-FF-dl(11) }
Rx accumulated bit error rate
as 100000000 *
Syntax: Integer32
A table of radio statistics by carrier and stream index.
Syntax: SEQUENCE OF XgRfChainStatEntry
Each entry contains statistics by carrier and stream index. These indexes coupled together give unique index of radio chain.
Syntax: XgRfChainStatEntry
Radio carrier index, ranging from 1 to maximum carrier number used.
Syntax: Integer32 (1..2)
Radio stream index, ranging from 1 to maximum streams per carrier. Streams count varies depending on anthenna metod used: SISO, MIMO, double SISO, etc.
Syntax: Integer32 (1..2)
Tx modulation index.
Syntax: INTEGER { qpsk-1-4(0), qpsk-1-2(1), qpsk-3-4(2), qam16-1-2(3), qam16-3-4(4), qam64-4-6(5), qam64-5-6(6), qam256-6-8(7), qam256-7-8(8), qam256-30-32(9), qam1024-8-10(10) }
Rx modulation index.
Syntax: INTEGER { qpsk-1-4(0), qpsk-1-2(1), qpsk-3-4(2), qam16-1-2(3), qam16-3-4(4), qam64-4-6(5), qam64-5-6(6), qam256-6-8(7), qam256-7-8(8), qam256-30-32(9), qam1024-8-10(10) }
Carrier to Interference + Noise Ratio
Syntax: Integer32
Absolute Received Signal Strength Indicator
Syntax: Integer32
Valid air block counter
Syntax: Counter32
Invalid air block counter
Syntax: Counter32
Measured TX power in hundredths of dB.
Syntax: Integer32 (0..2700)
RSSI at ADC input per stream in dB
Syntax: Integer32
TX gain in hundredth of dB, stepping by 0.25 dB
Syntax: Integer32
Deliberate CINR addition used to shift MCS selection while keeping BER as close as possible below allowed level.
Syntax: Integer32
Bit Error rate: least detectable value 1 correspomds to 1e-8; most possible value 100000000 means 1.0 special value -1 is used when no data for estimation are available
Syntax: Integer32 (-1..100000000)
BER AMC 1 minute Error: least detectable value 1 correspomds to 1e-8; most possible value 100000000 means 1.0 special value -1 is used when no data for estimation are available
Syntax: Integer32 (-1..100000000)
BER AMC 10 minutes Error: least detectable value 1 correspomds to 1e-8; most possible value 100000000 means 1.0 special value -1 is used when no data for estimation are available
Syntax: Integer32 (-1..100000000)
BER AMC 1 hour Error: least detectable value 1 correspomds to 1e-8; most possible value 100000000 means 1.0 special value -1 is used when no data for estimation are available
Syntax: Integer32 (-1..100000000)
symbol time offset deviation, measured in tenths of sample
Syntax: Integer32
Catalina temperature in degrees Celsius.
Syntax: Integer32
Amount of octets tramsmitted via radio interface.
Syntax: Counter32
Amount of octets received from radio interface.
Syntax: Counter32
The xgRadio group of objects provided for observation and manipulation with XG radio parameters.
Objects:
xgUnitType, xgCellId, xgQosStrategy, xgDlQuota, xgFrameLength, xgMaxDistance, xgChannelWidth, xgCCIndex, xgCcMaxTxPwr, xgCcFreqDl, xgCcFreqUl, xgCcAmcMode, xgCcAmcStrategy, xgOwnRadioIfIndex, xgLinkStatus, xgDistance, xgDlQuotaActual, xgTotalTxAirFrames, xgTotalTxPackets, xgTotalRxAirFrames, xgTotalRxPackets, xgTotalRxOkABs, xgTotalRxErrorABs, xgTotalDlCapacity, xgTotalUlCapacity, xgRfCarrierIndex, xgRfGoodRxFrames, xgRfBadRxFrames, xgRfTxFrequency, xgRfRxFrequency, xgRfDfsStatus, xgRfRxAccFER, xgRfChainCarrierIndex, xgRfChainStreamIndex, xgTxMCS, xgRxMCS, xgCINR, xgABSRSSI, xgRxOkABs, xgRxErrorABs, xgTxPwrActual, xgADCRSSI, xgTxGain, xgBerAmcCorrection, xgBerAmcWindowErr, xgBerAmcOneMinuteErr, xgBerAmcTenMinutesErr, xgBerAmcOneHourErr, xgSTOD, xgCatalinaTemp, xgTotalTxOctets, xgTotalRxOctets